Assembly Instructions for the Fitted Wardrobes
Follow the fitted wardrobes’ assembly instructions, including attaching side scribe panels.
Starting the Frame Assembly
Take the left side panel and screw in the adjustable legs adding dowels and cam pins. Then, repeat with the right side.
Attaching Braces and Assembling the Frame
With the left side standing upright, attach the two L-shaped braces to the front cam pins screwing in tightly. Fit the three flat rear braces into the cam pins at the rear and then attach the right side panel to create the cabinet frame.
Adjusting Legs
Adjust the legs with the screwdriver. The top of the legs should be below the level of the front brace and the rear panel groove (25 mm gap between the bottom of the cabinet and floor).
Attaching the Back Panel
Slot the wardrobe’s back panel into place and fix it using two 30 mm screws through the holes in the top.
Final Placement and Levelling
Move the wardrobe to its final place and ensure its level by adjusting the legs and using a spirit level. You can now add any other cabinets and fix them to the wall that make up your wardrobe.
Fitting the Plinth
Cut and scribe top and bottom plinths to suit your space for a floor-to-ceiling look. Now, clamp the plinth to the L-shaped brace and screw them together from the inside.
Attaching Panels
Insert top and bottom panels by sliding into the groove of the back panel and then laying flat. This should be a tight fit to keep things secure. Using 40 mm screws, fix the panels into place.
Installing Drawers
For the drawers, please pay close attention to the positioning of the holes and drawer runners. The draw box will arrive pre-built; slide the runners out fully. Place the draw box on top, and it should click into place.
Attaching Wardrobe Doors
For wardrobe doors, insert the hinge into the door and close the cover plate to lock it into place. Then, line up against the holes of the cabinet, which will require two individuals.
Adding Handles
Add your handles for ultimate flexibility. Please note that the holes are not pre-drilled for handles, allowing you to place them wherever works best for you.
Attaching End Panel (If applicable)
You must attach your end panel if your wardrobe has an open end. Drill holes through the inside of the cabinet. To avoid any bowing over time, it is recommended to have a hole at the top, middle, and bottom. Then, attach the end panel and screw in from the inside.
Scribing Panel and Fitting
Place the scribed panel against your wall. Rest a pencil on the wall and draw a line around the scribe panel. This will show any undulations in the wall surface if it’s uneven.
Cut the Line and Smooth the Panel
You can then cut the line and smooth the panel with a circular saw and sander. Place the panel back against the wall and measure the gap between the wall and the wardrobe. Then, cut the panel to size.
Final Fitting of the Scribe Panel
With a 4mm drill bit, drill four holes inside your cabinet, which should be 9 mm from the front edge. Fit the panel into the gap and screw through the holes using 40 mm screws.
Finishing Touches
For the best finish, use a colour that matches the silicon between the panel and the wall. Cut and scribe the top and bottom plinths to suit your space for a floor-to-ceiling look. Clamp the plinth to the L-shaped brace and screw them together from the inside. Your wardrobe is complete.
